Type of Machine : 2 brush rolls over gantry type with 17 Oscillating Nozzles
• Washing Height: 3385 mm
• Machine Height: 4190 mm is based on 3385 mm washing capacity add 300mm for each increase in washing capacity up to maximum of 4572 mm
• Machine Width: 4255 mm
• Machine Length: 1770 mm
• Electric Supply: 400/440 V, 3 Phase 50 cycle with Neutral.
• Power Required: 4.8 KVA
• Time of Wash Cycle: 3 Minutes
• Starting Method: Pushing button/vehicle actuated
• 2 Side Brush Motor (each): 1.1kw
• 2 Gantry Motor (each): 0.37kw
• Water Spray Pump: 2.2kw
• Number of brushes left side- 09No.
• Number of brushes Right side- 09No.
• Emergency reverse push button – yes
• Hose pipe length – 09mtr.
• Guide Rail line length -12mtr.
• Proximity Switch A/c – 02No
• Emergency stop -yes
• Control panel Relay/Plc. – Relay
2 Brush Automatic Bus Washing Machine (Bay)
- • The operation of the new generation of SARV –PREMIER vehicle Washing Machine is monitored by a CONTROL PANEL, consisting of contactors, relays and timers or PLC Controlled panel.
• The traffic light shows green. The Vehicle drives into the wash bay between the guide rails, stopping immediately in front of Machine. The engine must be stopped and the hand brake firmly applied.
• The driver/operator pushes the start button. The side brushes are released, start rotating and move to their inner operating positions. The Machine moves towards the vehicle. After a short delay (2-3 seconds).
• The side brushes the water pump and detergent pump are switched on. The brush spray system starts operating.
• Contact the vehicle deviate outwards freely to accommodate the vehicle width. Their outward movement is hydraulically damped to prevent brush bounce.
• After two seconds delay the oscillation motor and blaster pump starts. The Oscillating Blasters spray water to cover the front, roof & rear of bus.
• At the end of first traverse, the Machine stops, the water and detergent pump injection system is switched off.
• After a short delay to allow the detergent to be cleared from the spray system the Machine commences its return traverse.
A full brush washing operation is again completed, with the side brushes in contact with the vehicle and the vehicle thoroughly rinsed the water. On the return of the Machine to its starting position, the spray system is switched off.
• The brushes stop rotating allowing a clear passageway for the vehicle to be driven through the Machine and out of the wash bay. The complete washing operation is fully automatic.
• The Machine travels only the length as designated. The approximate time of the complete wash cycle is 3 minutes for a large commercial vehicle or coach.
Description
Related products
Start typing to see products you are looking for.
Reviews
There are no reviews yet.